CCNA Cisco Exploration 1: Final toets antwoorden / CCNA Network Fundamentals Final exam answers

CCNA Exploration 1:  Network Fundamentals  Final Exam Answers 1. Refer to the exhibit. Host B attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured at the FastEthernet interface fa0/1 of the San Francisco router. The packet inside the captured frame has the source IP address 10.10.1.2, and the destination IP address is 10.31.1.20. What is the destination MAC address...

Read more ...

CCNA Cisco Exploration 1: Chapter 11 toets antwoorden / CCNA Network Fundamentals exam 11 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 11 Exam Answers1.Refer to the exhibit. What additional command is required to allow remote access to this switch?NA-SW1(config-if)# no shutdownNA-SW1(config)# enable password passwordNA-SW1(config)# ip default-gateway addressNA-SW1(config-if)# description description2. Immediately after a router completes its boot sequence, the network administrator wants to check...

Read more ...

CCNA Cisco Exploration 1: Chapter 10 toets antwoorden / CCNA Network Fundamentals exam 10 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 10 Exam Answers 1. Refer to the exhibit. A student working in the lab selects a cable that is wired as shown. Which connection types can successfully be made with this cable? (Choose two.) • connecting a PC to a router's console port • connecting two routers together via their fast ethernet ports • connecting two switches together at gigabit speeds • connecting...

Read more ...

CCNA Cisco Exploration 1: Chapter 9 toets antwoorden / CCNA Network Fundamentals exam 9 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 9 Exam Answers1. In the graphic, Host A has reached 50% completion in sending a 1 KB Ethernet frame to Host D when Host B wishes to transmit its own frame to Host C. What must Host B do? • Host B can transmit immediately since it is connected on its own cable segment. • Host B must wait to receive a CSMA transmission from the hub, to signal its turn. • Host B must...

Read more ...

CCNA Cisco Exploration 1: Chapter 8 toets antwoorden / CCNA Network Fundamentals exam 8 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 8 Exam Answers1. Which type of cable run is most often associated with fiber-optic cable?backbone cablehorizontal cablepatch cablework area cable 2. In most business LANs, which connector is used with twisted-pair networking cable?BNCRJ-11RJ-45Type F3. When is a straight-through cable used in a network?when connecting a router through the console portwhen connecting...

Read more ...

CCNA Cisco Exploration 1: Chapter 7 toets antwoorden / CCNA Network Fundamentals exam 7 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 7 Exam Answers1. Which three factors should be considered when implementing a Layer 2 protocol in a network? (Choose three.)• the Layer 3 protocol selected• the geographic scope of the network• the PDU defined by the transport layer• the physical layer implementation• he number of hosts to be interconnected2. Refer to the exhibit. Assuming that the network in the exhibit...

Read more ...

CCNA Cisco Exploration 1: Chapter 6 toets antwoorden / CCNA Network Fundamentals exam 6 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 6 Exam Answers1.Refer to the exhibit. Why would the response shown be displayed after issuing the command ping 127.0.0.1 on a PC? The IP settings are not properly configured on the host. Internet Protocol is not properly installed on the host. There is a problem at the physical or data link layer. The default gateway device is not operating. A router on the path...

Read more ...

CCNA Cisco Exploration 1: Chapter 5 toets antwoorden / CCNA Network Fundamentals exam 5 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 5 Exam Answers1. In an IPv4 environment, what information is used by the router to forward data packets from one interface of a router to another?• destination network address• source network address• source MAC address• well known port destination address2. What information is added during encapsulation at OSI Layer 3?• source and destination MAC• source and destination...

Read more ...

CCNA Cisco Exploration 1: Chapter 4 toets antwoorden / CCNA Network Fundamentals exam 4 answers

CCNA Exploration 1:  Network Fundamentals  Chapter 4 Exam Answers 1. Based on the transport layer header shown in the diagram, which of the following statements describe the established session? (Choose two.)• This is a UDP header.• This contains a Telnet request.• This contains a TFTP data transfer.• The return packet...

Read more ...